Content
Setup
1) Download the current version for Windows: https://www.wireguard.com/install/ and install
2) Run C:\Program Files\WireGuard\wireguard.exe and add an empty tunnel (we will configure the server side):
Add tunnel → Add empty tunnel ...
We register the settings:
Name - the name of the network connection
Public key - public key of the WireGuard server (needed to configure the client side)
[Interface]
PrivateKey = # private key of WireGuard server
ListenPort = # port that WireGuard will listen to
Address = # desired IP address of WireGuard server
Enable settings to allow the WG server to use the main network interface
3) Add another empty tunnel (we will configure the client side):Add tunnel → Add empty tunnel
We register the settings:
Name - the name of the network connection
Public key - the public key of the WireGuard client (needed to configure the server side)
[Interface]
PrivateKey = # WireGuard client private key
Address = # desired IP address of WireGuard client
[Peer]
PublicKey = # public key of the WireGuard server (from step 2)
AllowedIPs = # specify the IP addresses for which you want to use the created WG tunnel (specifying the subnet 0.0.0.0/0 will allow you to route all traffic to the WG tunnel)
Endpoint = # Server IP address (real, not WireGuard) and port that WireGuard server listens on (configured in step 2)
4) Now we need to add our client to the WireGuard server part, to do this go back to step 2 and add its config:
...
[Peer]
PublicKey = #WireGuard client public key (from step 3)
AllowedIPs = #IPuser address
5) Now it is sufficient to export the configuration files Export all tunnels to zip→ Specify location for export→Save
Next, open the saved archive, there will be configurations of all our tunnels.
Give the client its configuration file.
6) On the server, select the server config and run the program
7) On the client add configuration file to WireGuard.Add Tunnel→Select client configuration file->Open
Select client config and run
This completes the configuration of the first client, similarly configuring the other clients by adding their data to the server config (step 4)
Auto-start WireGuard after a server restart.
1) Add the startup file to the Windows scheduler autorun:Start→taskschd.msc
Click on "Create simple task" → Enter a Name for the task (e.g. wireguard) → Next
Select "On computer startup"→ Next
Select "Start programme"→ Next
In the "Program or Script" field, select our file to run WireGuard (default is "C:\Program Files\WireGuard\wireguard.exe")
Add arguments:
/installtunnelservice "C:\Program Files\WireGuard\wg_server.conf"
where:
C:\Program Files\WireGuard\wg_server.conf - расположение конфигурационного файла *.conf
Check "Open the Properties window for this task after you have clicked 'Done'"→ Done
In the window that opens, tick the "Run with the highest rights"→OK
Done. Do a reboot, check
