Remove-GlobalAddressList (ExchangePowerShell) (2024)

• Reference

Module:

ExchangePowerShell

Applies to:

Exchange Server 2010, Exchange Server 2013, Exchange Server 2016, Exchange Server 2019, Exchange Online

This cmdlet is available in on-premises Exchange and in the cloud-based service. Some parameters and settings may be exclusive to one environment or the other.

Use the Remove-GlobalAddressList cmdlet to remove an existing global address list (GAL).

In Exchange Online, this cmdlet is available only in the Address Lists role, and by default, the role isn't assigned to any role groups. To use this cmdlet, you need to add the Address Lists role to a role group (for example, to the Organization Management role group). For more information, see Add a role to a role group.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

• Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
• Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.

This parameter is available only in on-premises Exchange.

The DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory. You identify the domain controller by its fully qualified domain name (FQDN). For example, dc01.contoso.com.

The Identity parameter specifies the global address list that you want to remove. You can use any value that uniquely identifies the GAL. For example:

• Name
• Distinguished name (DN)
• GUID

The WhatIf switch simulates the actions of the command. You can use this switch to view the changes that would occur without actually applying those changes. You don't need to specify a value with this switch.