The information in this article can help you when you are unable to connect your Nintendo Switch console to a wired or wireless network and you receive an error code between 2110-3000 and 2110-3999.
This article is for a general range of error codes. Prior to using the following steps, ensure you have searched the correct error code, and that there is no article specific to that error code.
Test your connection after any changes are made to the Nintendo Switch console or network environment to determine if the change resolves your issue.
A USB LAN Adapter is required to set up a Wired Internet connection when using a Nintendo Switch dock without a LAN port.
A USB LAN Adapter can be connected to Nintendo Switch Lite using a licensed accessory, such as the Dual USB PlayStand for Nintendo Switch Lite from HORI.
Note
Error codes in this range generally indicate an error occurred when the Nintendo Switch console attempted to initially connect to a wired or wireless router (usually prior to obtaining an IP address).
This may occur if the Internet settings were set up incorrectly, or if the Nintendo Switch console could not locate the wired or wireless router.
Error codes in this range generally indicate an error occurred when the Nintendo Switch console attempted to initially connect to a wired or wireless router (usually prior to obtaining an IP address).
What to do. Restart the Nintendo Switch console by holding down the POWER Button for three seconds, then select Power Options followed by Restart. If the console does not respond, hold down the POWER Button for twelve seconds to force it to shut down, then power on the console again.
2101-0001 is an error on the i2c bus. This is a faulty M92 in MOST cases. There are cases where it can be something such as a faulty charging cable, excessive force, or accidental damage when inserting and removing the charging cable. It is not usually an error that will just occur on its own for no reason.
Error codes in this range generally indicate an error occurred when the Nintendo Switch console attempted to initially connect to a wired or wireless router (usually prior to obtaining an IP address).
This error code indicates the internet connection you are attempting to use likely requires some type of authentication through a web browser (such as agreeing to terms of service or entering a username and password).
Error codes in this range generally indicate an error occurred before the Nintendo Switch console attempted to connect to a wired or wireless router. This may occur if the Internet settings were set up incorrectly, or if the Nintendo Switch console could not locate the wired or wireless router.
This error code indicates a potential issue related to the DNS being used. This error may be the result of an incorrect DNS entered into the console's Internet settings, or an issue with the ISP or DNS service you are attempting to use.
Generally, you're looking at anywhere from $40 to $180. That's quite the range, right? Let's break it down a bit more. Minor repairs, like fixing a broken button, might be on the lower end of that scale.
Possible Solutions: Restart the Nintendo Switch console. To restart the console, hold the POWER Button for three seconds, then select "Power Options", followed by "Restart". Ensure your router's wireless security key setting is compatible with Nintendo Switch.
This error code typically indicates that the Nintendo Switch console was unable to detect a network which matches any of the saved networks within the internet settings.
Introduction: My name is Pres. Lawanda Wiegand, I am a inquisitive, helpful, glamorous, cheerful, open, clever, innocent person who loves writing and wants to share my knowledge and understanding with you.
We notice you're using an ad blocker
Without advertising income, we can't keep making this site awesome for you.