How To Reduce Raspberry Pi 5, 4 Standby Power Consumption (2024)

The Raspberry Pi 5 is a powerful board, in terms of processing power and how much it can consume. But did you know that the Raspberry Pi 5 (and the 4 before it) consumes power when in standby mode?

When powered off and in standby the Raspberry Pi 5 can consume 1.29 Watts of power. It will sit there with the power LED lit and the SoC powered up ready. The reason for this is that some HATs have an issue with the 3v3 rail being powered off, but the 5V, passed through from the USB power supply being active.

What if we could lower our power consumption at standby by 185% with just one line of code? We can do that using a little Linux magic. Reducing the standby power is useful for mobile and battery powered projects. It will help prolong the life of the project and require less frequent battery charges.

Reducing Raspberry Pi 5 Power Consumption

This hack is easy, all we need to do is alter a configuration file, reboot and we can enjoy a lower standby power consumption.

1. Open a Terminal and run this command. This will open a nano text editor where we can make changes to the EEPROM.

sudo rpi-eeprom-config --edit

2. Scroll down and change the following line.

POWER_OFF_ON_HALT=0Change toPOWER_OFF_ON_HALT=1

3. Press CTRL + X, Y and then ENTER to save and exit.

Reboot the Raspberry Pi to write the changes to the EEPROM. When powered off, your Raspberry Pi 5 will now consume much less power in standby.

Reducing Raspberry Pi 4 Power Consumption

On the Raspberry Pi 4 we need to take an additional step to tweak the standby power. That step is to turn off “wake on GPIO.” This line is found in the same config file.

1. Open a Terminal and run this command. This will open a nano text editor where we can make changes to the EEPROM.

sudo rpi-eeprom-config --edit

2. Scroll down and change the following line. If this line is missing, add it.

POWER_OFF_ON_HALT=0Change toPOWER_OFF_ON_HALT=1

3. Change this line to turn off wake on GPIO.

WAKE_ON_GPIO=0

4. Press CTRL + X, Y and then ENTER to save and exit.

5. Reboot the Raspberry Pi to write the changes to the EEPROM. When powered off, your Raspberry Pi 5 will now consume much less power in standby.